Step 5
For Standard Installation:
Locate downrod assembly (3). Loosen ball screw
on black hanging ball to free lock pin. Black hanging ball will slide down.
Remove ground screw and green ground wire. Remove hanging ball from
downrod and save all parts. Insert fan wires through downrod. Screw
downrod into top of fan motor housing, being careful that wires are pulled
through. (see figure A)
For Industrial Installation:
Remove black ball from downrod as described
above. Insert fan wires through downrod. Screw downrod into top of fan
motor housing, being careful that wires are pulled through. (see figure B)
5
Figure A: Standard Installation
Figure B: Industrial Installation
Fan Motor Housing
Downrod
Fan Motor Housing
Hanging Ball
Lock Pin
Downrod
Ball Screw
Green Ground
Wire
Downrod
Assembly
(#3)
6
Step 6
Position the downrod so the hole in the downrod aligns with the hole in the
coupling on the motor. Insert safety bolt (S6) through coupling and downrod
and attach nut. Tighten firmly. Tighten set screw "A" against downrod. Place
flange cover (6) over downrod assembly until it covers flange. Attach flange
cover (6) by tightening screw (S2) against side of downrod. Place canopy
(5) over downrod (3).
For Standard Installation:
Replace hanging ball, insert hanging pin through
downrod and tighten set screw "C" in hanging ball into downrod.
Safety Bolt
and Nut (S6)
Set Screw (A)
Canopy (5)
Set Screw (C)
Downrod (3)
Flange Cover (6)
Motor Housing (7)
Screw (S2)
Screw (S2)
Standard Installation
Ground
Wire
Ball
Screw
Hanging
Pin
Hanging
Ball
Threaded
Set Screw Hole
WARNING:
Failure to completely tighten downrod as described
in steps 5 & 6 above could result in the fan loosening and possibly falling.
