Light Assembly
Housing
Motor Flywheel
Housing Slot
11
For blade assembly,
position blade through slot
in fan motor housing so
that all screw holes are
aligned (as shown in figure
below). Position light
house assembly so that the
top screw hole in blade
lines up with housing slot
in flywheel. Using motor
screws (S5), insert through
blade and into the fan
motor. Tighten securely.
Step 11 - 5 Blade Installation
11
12
Step 12
1. Install 3-40W light bulbs. Slide glass fixture (#8) onto motor housing
(#5). Secure by placing glass mounting bracket (#7) onto motor housing
using the screws provided on bottom of motor housing (#5). Twist clockwise
to lock into place. Tighten screws firmly. Next twist glass mounting bracket
screw (S9) onto bottom of glass mounting bracket (#7). Tighten firmly.
2. To install the Switch Housing Assembly (#9), locate both modular wiring
plugs (A) and (B). One extends from the mounting plate (E) on bottom of
fan body and one extends from the Switch Housing (#9). Align the two
plugs so the latch on the side of the plugs will engage when pushed together.
Push the two plugs firmly together until latched.
3. Raise switch housing assembly (#9) over glass mounting bracket (#7) and
secure with finial (S12).
IMPORTANT:
Be sure that no wires are caught or pinched during assembly.
Modular Wiring Plug (A)
Mounting Plate (E)
Modular Wiring Plug (B)
Switch Housing (#9)
Glass (#8)
Finial (S12)
Mounting Bracket (#7)
Fan Housing & Motor (#5)
Switch Housing Screw (S9)
