page 9
10. Assembly of Handheld Remote Control.
IN ORDER TO USE THE HANDHELD REMOTE CONTROL,
PLEASE CONTINUE WITH SECTION 10 for remote control
assembly instructions. If you have already installed the
wall control but do
not
wish to use the handheld
remote control, please proceed to Section 11.
Gently pull on remote control cover to separate top
and bottom parts. [
Refer to
diagram 1
.
]
In order to use wall control as a handheld remote
control, cut each wire on wall control (that was not
previously used)--use wire cutters to cut off each wire
as close to the wall control as possible. [
Refer to
diagram 2
.
]
Install one 12-volt battery (included) in wall control.
[
Refer to
diagram 2
.
]
Since this fan comes with pre-installed LED bulbs, the
dimmer switch (labeled
DIM
and
ON
) has been
pre-set to the "ON" position (
DIM
). If you do not wish
to have dimming capability, please move the switch
to the "OFF" position (
ON
). [
Refer to
diagram 2
.
]
Attach
black faceplate
to front of wall control; press
down firmly. [
Refer to
diagram 3
.
]
Align holes in wall control with posts located on
inside
of TOP part of remote control cover and press
together firmly. Place wall control into BOTTOM part
of remote control cover, aligning posts in top of
remote control cover with post holes in the bottom.
[
Refer to
diagram 3
.
]
(
NOTE
: Make sure to align narrower ends of remote
control cover before closing.) Squeeze top and
bottom of remote control cover together until you
hear a click at each end, indicating that the remote
control cover has closed completely.
IMPORTANT
: Store the handheld remote control
away from excess heat or humidity. To prevent
damage to handheld remote control, remove the
battery if handheld remote control will not be
used for long periods.
CAUTION
: “DO NOT DISPOSE OF BATTERIES IN
FIRE, BATTERIES MAY EXPLODE OR LEAK.” - When
disposing of household alkaline batteries, it is
best to check with your local and state recycling
or household hazardous waste coordinators
concerning the specifics of the program in your
area. You may also locate a recycling center by
calling 1-800-8-BATTERY or 1-877-2-RECYCLE or
visit www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
WARNING
:
Choking Hazard
- Small parts. Keep
battery away from children.
(top)
(bottom)
remote control
cover
diagram 1
diagram 2
dimmer
switch
wall control
wire
wire
wire
12V battery
1
1
-
2
2
-
DIM ON
1
1
-
2
2
-
DIM ON
wall
control
face-
plate
remote control
cover,
BOTTOM
post
hole
post
hole
remote control
cover,
TOP
diagram 3
