page 10
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light switch
(if applicable). Test wall control (optional installation) by
locating ON/OFF slider switch on wall control, then set to the
ON position. Test light and dimmer function and then test
fan speeds. Next, locate handheld remote control. Test the
light ON/OFF function by pressing the L2 button; test the
dimmer function by pressing the L2 button and holding it
down for
1 second. Test fan speeds with the different fan speed
buttons. If the wall and/or handheld remote control
operates all of the functions of the fan, battery has been
installed correctly. If the wall and/or handheld remote
control do (does) not operate all of the fan/light functions,
refer to "Troubleshooting" section to solve any issues before
contacting Customer Service.
Fan
must
be on LOW
before
setting the fan to reverse
direction. Use "reverse" button to recirculate air depending
on the season.
NOTE
: If the wall control/handheld remote control interferes
with other appliances, go back to the instructions in Section
11 above.
13. Testing Your Fan.
12. Remote Control Operation.
ON/OFF
slider switch - turns
wall control
ON or OFF
(switch not functional on handheld remote)
HIGH
button - turns
fan
to HIGH speed
MED
button - turns
fan
to MEDIUM speed
LOW
button - turns
fan
to LOW speed
OFF
button - turns
fan
OFF
L1
button - (not applicable for this fan)
L2
button -
turns
light kit
ON/OFF when pressed once;
dims
light kit
when pressed and held down
REV
button - used to REVERSE blade direction
(fan must be set on
low
before
reversing blade
direction)
1
1
-
2
2
-
1
1
-
2
2
-
11. Automated Learning Process./Activating Code.
CAUTION
:
The wall and/or handheld remote control can be programmed to multiple receivers or fans. If this is not desired,
turn wall switch off to any other programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on wall control to the ON position. Within
60 seconds of turning on the wall control, press and hold the
OFF
button on the wall control for 5 seconds or until
light blinks twice.
Turn power off again for at least 5 seconds
and then turn power back on. Within 60 seconds of restoring the power,
press and hold the
OFF
button on the front of the handheld remote control for 5 seconds or until light blinks twice.
Test the light and fan functions to confirm the learning process is complete--
see Section 13 below.
wall control
handheld
remote control
motor housing
1
1
-
2
2
-
