10. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Restore power from
circuit box and light switch (if applicable). Test
fan speeds with the pull chain. Start at the OFF
position (no blade movement). First pull will
set the fan to HIGH. Second pull will set the
fan to MEDIUM-HIGH. Third pull will set the fan
to MEDIUM-LOW. Fourth pull will the fan to
LOW. Fifth pull will again set the fan to OFF
setting. (diagram 1) If fan does not function,
please refer to "Troubleshooting" section to
solve any issues before contacting Customer
Service.
Turn fan completely off before moving the
reverse switch. Set reverse switch to
recirculate air depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the
RIGHT for fan to function. If the reverse switch
is set in the middle position (diagram 4), fan
will not operate.
Attach pull chain extension supplied or
custom pull chain extension (sold separately)
to the end of the pull chain.
page 9
pull chain
extension
reverse switch
motor housing
switch
housing
diagram 2
diagram 3
diagram 4
diagram 1
