8. Blade Assembly.
motor
housing
blade arm
blade
blade attachment
screws/washers
9. Switch Housing Assembly.
switch housing plate
fitter
plate
motor
housing
blade arm screws/
lock washers
page 8
WARNING: To reduce the risk of serious
bodily injury,
DO NOT use power tools to
assemble the blades. If screws are
overtightened, blades may crack and break.
Locate 15 blade attachment screws/washers
in hardware pack. Hold blade arm up to
blade and align holes. Insert 3 blade
attachment screws (along with washers)
with fingers first and then tighten screws
securely with Phillips screwdriver. Repeat
procedure for the remaining blades.
Locate 10 blade arm screws/lock washers in
hardware pack. Align blade arm holes with
motor screw holes and attach one blade arm
with blade arm screws/lock washers. Before
securing screws permanently, repeat
procedure with remaining blade arms.
Securely tighten all screws.
NOTE: Tighten blade arm screws twice a
year.
Remove 3 screws from outer edge of switch
housing plate (save screws for later use).
Remove 1 screw from fitter plate on
underside of motor housing and partially
loosen the other 2 screws. Align slotted
holes in center of switch housing plate with
loosened screws in fitter plate, allowing male
plug from motor housing to come through
hole in middle of switch housing plate. Twist
switch housing plate to lock. Re-insert screw
that was removed and secure all screws.
Connect male plug from motor housing to
female plug from switch housing, matching
up the colors on the male plug with the
colors on the female plug for correct fit.
Make sure plugs connect tightly.
Align holes in switch housing with holes in
switch housing plate. Re-insert screws that
were previously removed and use a Phillips
screwdriver to secure all screws.
switch housing
male plug
female plug
