page 5
5. Fan Assembly.
Remove blade arm screws and lock washers from
underside of motor in order to remove blue
motor stabilization plate. (Blue motor stabilization
plate may be discarded once removed.) [Refer to
diagram 1.]
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower
hanging ball and remove stop pin and then slide
hanging ball off of the downrod. [Refer to
diagram 2.]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor
housing yoke. [Refer to diagram 3.]
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod. [Refer to diagram 3.]
Determine the length of downrod you wish to
use. Thread safety cable and electrical wires
through threaded end of downrod and pull extra
wire slack from the upper end of the downrod.
[Refer to diagram 3.]
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align with
holes in yoke--make sure wires do not get twisted.
Re-insert pin and clip that were previously
removed. Tighten yoke set screws and nuts
securely. [Refer to diagram 3.]
Locate canopy cover in hardware pack. Slide yoke
cover, canopy cover and canopy over downrod.
[Refer to diagram 4.] (Note: Canopy cover must be
turned with shiny side toward the motor housing.)
["Fan Assembly" continued on next page.]
stabilization
plate
set screw
hanging ball
stop pin
diagram 3
motor
housing
canopy
canopy cover
downrod
yoke cover
downrod
electrical wiring
yoke set screw
and nut
pin
clip
motor
housing
safety cable
diagram 4
NOTE: The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common
sense and caution are necessary factors in the
installation and operation of this fan.
diagram 2
diagram 1
