page 7
9. Blade Assembly.
8. Canopy Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen
the other screw. Lift canopy to hanging
bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging
bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then
tighten both screws securely. Slide canopy
cover up to canopy, aligning rounded part of
slotted holes in canopy cover with
screwheads in bottom of canopy. Turn canopy
cover to the right (clockwise) until it stops.
WARNING
: To reduce the risk of serious
bodily injury,
DO NOT use power tools to
assemble the blades. If overtightened, blades
may crack and break.
Locate 15 blade attachment screws/washers
in hardware pack. Hold blade arm up to blade
and align holes. Insert 3 blade attachment
screws/washers with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat for the remaining blades.
Remove blade arm screws/lock washers from
underside of motor. Align one blade arm holes
with motor screw holes and attach blade arm
with blade arm screws/lock washers. Before
securing screws permanently, repeat with
remaining blade arms. Securely tighten all
screws.
Note
: Tighten blade arm screws twice a year.
motor housing
blade
blade attachment
screws/washers
blade arm screws/lock washers
blade arm
hanging
bracket
canopy
screw
screw
canopy cover
