page 5
5. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Remove pin
and clip. Lower hanging ball and remove stop pin.
Then slide hanging ball off downrod.
[
Refer to
diagram 1
.
]
Remove vice from safety cable by loosening the
screw and nut on the vice. Loosen yoke set screws
and nuts at top of motor housing.
[
Refer to
diagram 2
.
]
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
[
Refer to
diagram 2
.
]
Determine the length of downrod you wish to use.
Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack
from the upper end of the downrod.
[
Refer to
diagram 2
.
]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes
in yoke--
make sure wires do not get twisted
.
Re-insert pin and clip previously removed. Tighten
yoke set screws and nuts securely.
[
Refer to
diagram 2
.
]
Slide weatherproof yoke cover and canopy over
downrod.
[
Refer to
diagram 3
.
]
Thread safety cable and wires through hanging ball
and then slide hanging ball over downrod--the top
of the downrod should be noted as having a set
screw hole; use this hole when setting the set
screw. Insert stop pin into top of downrod and raise
hanging ball. Be sure stop pin aligns with slots on
the inside of the hanging ball. Tighten set screw
securely.
[
Refer to
diagram 4
.
]
WARNING
: Failure to tighten set screw (on hanging
ball) completely could result in the fan becoming
loose and possibly falling.
Remove electrical tape from electrical wiring and
thread one wire through each hole in the
weatherproof hanging ball cover. Pull
weatherproof hanging ball cover down securely
over hanging ball (on downrod).
[
Refer to
diagram 4
.
]
["Fan Assembly" continued on next page.]
diagram 1
diagram 4
vice
nut
screw
yoke set screw
and nut
pin
clip
downrod
electrical wiring
motor
housing
safety cable
set screw
hanging ball
stop pin
pin
clip
canopy
motor
housing
weatherproof
yoke cover
downrod
electrical wiring
hanging ball
safety cable
set screw hole
set screw
hanging ball
canopy
stop pin
weatherproof
hanging ball cover
electrical wiring
diagram 2
diagram 3
