page 4
4. Mounting Plate Installation.
ON
OFF
ON
OFF
Turn off circuit breakers to current fixture from breaker
panel and be sure operating light switch is turned to
the OFF position.
WARNING
: Failure to disconnect power supply prior to
installation may result in serious injury.
Remove existing fixture.
WARNING
: When using an existing outlet box, be sure the
outlet box is securely attached to the building structure
and can support the full weight of the fan. Ensure outlet
box is clearly marked "Suitable for Fan Support." If not, it
must be replaced with an approved outlet box. Failure to
do so can result in serious injury.
CAUTION
:
Be sure outlet box is grounded properly and
that a ground wire (
GREEN
or bare) is present.
Install mounting plate to outlet box using original
screws, spring washers and flat washers provided with
new or original outlet box.* Pull electrical wiring from
outlet box through center hole in the mounting plate.
Locate screw on outer edge of mounting plate closest
to the j-hook and remove that screw. Also, remove
screw on outer edge of mounting plate directly
opposite the screw that was just removed. Partially
loosen the other 2 screws.
*
Note
: It is very important that you use the proper
hardware when installing the mounting plate as this will
support the fan.
3. Installation Preparation.
This fan can be mounted as a
flushmount
on a
regular (no-slope) ceiling
only
.
Downrod
installations are
not
available for this fan.
Installation requires these tools:
Phillips screwdriver, flat-head screwdriver,
adjustable pliers or wrench, stepladder, wire
cutters, and rated electrical tape.
downrod
installation
flushmount
installation
CANNOT be
installed on
angled or
vaulted ceilings
blade edge
7 feet
(2.13m)
(76cm)
30
inches
12 f
t. - 15 f
t.
12 ft. - 15 ft.
(3.66m - 4.57m)
(3.66m - 4.57m)
To prevent personal injury and damage, ensure that
the hanging location allows the blades a clearance
of 7ft. (2.13m) from the floor and 30in. (76cm) from
any wall or obstruction.
This fan is suitable for room sizes up to 400 square
feet (20.9 square meters).
spring washers
flat washers
outlet box screws
mounting plate
