page 8
9. Light Kit Assembly.
Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws. Align slotted holes
in center of fitter plate with loosened screws
in motor plate, allowing molex connections
from motor housing to come through hole in
middle of fitter plate. Twist fitter plate to lock.
Re-insert screw that was previously removed
and securely tighten all 3 screws with a
Phillips screwdriver.
Remove 1 screw from post located on
underside of fitter plate and partially loosen
the other screws in the other two posts.
Connect
WHITE
wire from motor housing to
WHITE
wire from light kit fitter. Connect
BLACK
(or
BLUE
) wire from motor housing to
BLACK
wire from light kit fitter. Be sure molex
connections snap together securely.
Align slotted holes in light kit fitter with
loosened screws in fitter plate. Twist light kit
fitter to lock. Re-insert screw that was
previously removed and tighten all 3 screws
securely.
Install 3 candelabra base 40 watt max. bulbs,
(included).
Important
: When replacing bulbs, please
allow bulb(s) and glass shade to cool down
before touching them.
Align grooves on glass shade with nodules on
inside of light kit fitter and push up gently on
glass shade. Twist glass shade to the RIGHT
(clockwise) until glass shade locks into place.
Pull down VERY GENTLY on glass shade to make
sure that glass shade is secure.
fitter plate
molex connections
motor plate
motor housing
molex
connections
glass shade
fitter plate
light kit fitter
bulb
motor housing
