page 6
6. Wiring.
WARNING
: Turn off circuit breakers to current fixture
from breaker panel and be sure switch is turned to the
OFF position.
CAUTION
:
Be sure outlet box is properly grounded and
that a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If
you are unfamiliar with electrical wiring or if the
Note:
Excess lead wire length from the fan can be cut
to the desired length and then stripped.
When downrod is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect
BLACK
and
BLUE
wires from fan to
BLACK
wire
from ceiling with wire connector provided.
Connect
WHITE
wire from fan to
WHITE
wire from
ceiling with wire connector provided.
Connect all
GROUND
(
GREEN
) wires together from
fan to
BARE
/
GREEN
wire from ceiling with wire
connector provided.
If you intend to control the fan light with a separate
light switch, connect
BLUE
wire from fan to the
BLACK
(or
RED
) supply from the independent switch.
* Wrap each wire connector separately with electrical
tape as an extra safety measure.
This fan is remote control adaptable (remote control
sold separately).
Note
: Only remote controls approved
for DAMP locations can be used with this fan.
wire
connector
black
white
black supply wire
ground
(green
or bare)
white supply wire
ground
(green or bare)
*
5. Fan Assembly. (cont.)
With the hanging bracket secured to the outlet box and
able to support the fan, you are now ready to hang your
fan. Grab the fan firmly with two hands. Slide downrod
through opening in hanging bracket and let hanging ball
rest on the hanging bracket. Turn the hanging ball slot
until it lines up with the hanging bracket tab.
WARNING
: Failure to align slot in hanging ball with tab in
hanging bracket may result in serious injury or death.
Tip:
Seek the help of another person to hold the
stepladder in place and to help lift the fan up to you once
you are set on the ladder.
Find a secure attachment point (wood ceiling joist highly
recommended) and secure safety cable. It will be necessary
to use a heavy duty wood screw, washer and lock washer
(not supplied) with the safety cable loop. If necessary,
adjust the loop at the end of the safety cable. The loop at
the end of the safety cable should just fit over the threads
on the wood screw.
Test safety cable by pulling on loose
end of cable with plie rs. If the safety cable slips, the loop
must be adjusted tighter.
Extra cable slack can be left in
ceiling area.
motor housing
safety cable
hanging ball slot
wood ceiling joist
wood screw
and washer
safety cable loop
hanging bracket tab
black
white
blue
from fan
from
ceiling
