page 8
9. LED Light Kit Assembly.
fitter plate
LED light kit
shade
grooves
Remove 1 screw from motor plate on underside of
motor housing and partially loosen the other 2
screws. Align slotted holes in fitter plate with
loosened screws in motor plate, allowing molex
connections from motor housing to come
through holes in midde of fitter plate. Twist fitter
plate to lock. Re-insert screw that was just
removed and securely tighten all 3 screws with a
Phillips screwdriver.
Remove 1 screw from underside of fitter plate and
partially loosen the other 2 screws.
Connect
WHITE
wire from LED light kit to
WHITE
wire from motor housing. Connect
BLACK
wire
from LED light kit to
BLACK
(or
BLUE
) wire from
motor housing. Be sure that molex connections
snap together completely.
Carefully arrange wiring within LED light kit. Align
slotted holes in LED light kit with loosened screws
on fitter plate. Twist LED light kit to lock. Re-insert
screw that was previously removed and tighten all
3 screws securely.
Align grooves on shade with nodules on inside of
LED light kit and push up gently on shade. Twist
shade to the RIGHT (clockwise) until shade locks
into place.
Pull down VERY GENTLY on shade to make sure that
shade is secure.
motor plate
molex
connections
nodules
motor housing
