page 4
5. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower hanging
ball and remove stop pin and then slide hanging
ball off of the downrod.
[
Refer to
diagram 1
.
]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke.
[
Refer to
diagram 2
.
]
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
[
Refer to
diagram 2
.
]
Determine the length of downrod you wish to use.
Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack
from the upper end of the downrod.
[
Refer to
diagram 2
.
]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--
make sure wires do not get twisted
. Re-insert
pin and clip that were previously removed. Tighten
yoke set screws and nuts securely.
[
Refer to
diagram 2
.
]
Locate canopy cover and anti-sway adapter in
hardware pack. Slide canopy cover, anti-sway
adapter and canopy over downrod.
[
Refer to
diagram 3
.
]
(
Note
: Canopy cover must be turned
with shiny side
toward
motor housing. If using the
anti-sway adapter it must be turned with flat side
toward
the canopy.)
Thread safety cable and wires through hanging ball;
then slide hanging ball over downrod--the top of
the downrod should be noted as having a set screw
hole; use this hole when setting the set screw. Insert
stop pin into top of downrod and raise hanging ball.
Be sure stop pin aligns with slots on the inside of
the hanging ball. Tighten set screw securely.
[
Refer
to
diagram 4
.
]
WARNING
: Failure to tighten set screw completely
could result in the fan becoming loose and possibly
falling.
["Fan Assembly" continued on next page.]
set screw
hanging ball
stop pin
diagram 2
diagram 1
diagram 3
diagram 4
canopy
motor
housing
downrod
downrod
electrical wiring
safety cable
yoke set
screw
and nut
pin
clip
set screw hole
hanging
ball
stop pin
anti-sway
adapter
canopy cover
