13. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan
speeds with the pull chain on the switch
housing. Start at the OFF position (no blade
movement). First pull will set the fan to HI.
Second pull will set the fan to MEDIUM. Third
pull will set the fan to LOW. Fourth pull will again
set the fan to the OFF setting. Test light(s) with
the pull chain in the middle. If fan and light(s)
do not function, please refer to
“Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off
before
moving the
reverse switch (located on switch housing. Set
reverse switch to recirculate air depending on
the season:
- LEFT position in summer (
diagram 1
)
- RIGHT position in winter (
diagram 2
)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important
: Reverse switch must be set either
completely LEFT
or
completely RIGHT
for fan to
function. If the reverse switch is set in the
middle
position (
diagram 3
), fan will not operate.
Attach pull chain extensions provided or custom
pull chain extensions (sold separately) to the
ends of the corresponding pull chains.
diagram 1
diagram 2
diagram 3
page 12
