9. Switch Housing Assembly.
10. Testing Your Fan.
pull chain
extension
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with pull chain.
(
diagram 1
) Start at the OFF position (no blade
movement). First pull will set the fan to HI. Second pull
will set the fan to MEDIUM. Third pull will set the fan to
LOW. Fourth pull will again set the fan to the OFF
setting. If fan does not function, please refer to
"Troubleshooting" section to solve any issues before
contacting Customer Service.
Turn fan completely off
before
moving the reverse
switch. Set reverse switch to recirculate air depending
on the season:
- LEFT position in summer (
diagram 2
)
- RIGHT position in winter (
diagram 3
)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your comfort.
Important
: Reverse switch must be set either
completely to the LEFT
or
completely to the RIGHT
for
fan to function. If the reverse switch is set in the
middle
position (
diagram 4
), fan will not operate.
Attach pull chain extension supplied or custom pull
chain extension (sold separately) to the end of the
pull chain.
diagram 1
diagram 2
diagram 3
diagram 4
male plug
switch
housing
plate
motor
plate
motor
plate
screw
switch
housing
male plug
female plug
motor
housing
Remove 1 screw from motor plate (on
underside of motor) and partially loosen the
other 2 screws. Align slotted holes in middle
of switch housing plate with loosened screws
in motor plate, allowing male plug from
motor housing to come through hole in
middle of switch housing plate. Twist switch
housing plate to lock. Re-insert screw that
was just removed and tighten all 3 screws
securely.
Remove all 3 screws on outer edge of switch
housing plate. Connect male plug from fan to
female plug from switch housing, matching
up the colors on the male plug with the colors
on the female plug for correct fit. Be sure that
the plugs connect completely.
Align holes in switch housing with holes in
switch housing plate. Re-insert screws that
were previously removed and secure all 3
screws with a Phillips screwdriver.
motor
housing
switch
housing
plate
reverse
switch
page 9
