page 8
Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws.
Align slotted holes in fitter plate with loosened
screws in motor plate, allowing molex
connectors to come through center hole in
fitter plate. Twist fitter plate to lock. Re-insert
screw that was previously removed and
securely tighten all 3 screws with a Phillips
screwdriver.
Connect
WHITE
wire from motor housing to
WHITE
wire from the LED light kit and
BLUE
(or
BLACK
)
wire from motor housing to
BLACK
wire from LED light kit. Make sure
molex connections snap together completely.
Remove 3 screws from under fitter plate.
Carefully arrange wiring within the back of
LED light kit. Align holes in LED light kit
with holes in fitter plate. Re-insert screws
that were previously removed and securely
tighten all 3 screws with a Phillips
screwdriver.
Locate slots on glass shade and align with
nodules on inside of fitter plate.
Gently push
up on glass shade and turn
to the RIGHT
(clockwise)
until it slides completely into place.
9. Light Kit Assembly .
motor plate
motor housing
fitter plate
screw
molex connections
fitter plate
molex connections
LED light kit
motor housing
glass shade
nodules
slots
motor housing
