page 9
9. Light Kit Assembly. (cont.)
Align grooves on shade with nodules on inside of fitter
plate. Turn shade to the RIGHT (clockwise) until it no
longer turns.
NOTE: Pull down VERY GENTLY on shade to make sure
that shade is secured completely.
motor housing
shade
groove
10. Handheld Remote Control Assembly.
IN ORDER TO USE THE HANDHELD REMOTE CONTROL, PLEASE
CONTINUE WITH SECTION 10 for remote control assembly
instructions. If you have already installed the wall control but do
not wish to use the handheld remote control, please proceed to
Section 11.
Gently pull on remote control cover to separate top and
bottom parts. [Refer to diagram 1.]
In order to use wall control as a handheld remote control, cut
each wire on wall control (that was not previously used)--use
wire cutters to cut off each wire as close to the wall control as
possible. [Refer to diagram 2.]
Install one 12-volt battery (included) in wall control. [Refer to
diagram 2.]
WARNING: Battery is to be inserted with the correct polarity.
Since this fan comes with an LED light kit, the dimmer switch
(labeled DIM and ON) has been pre-set to the "ON" position
(DIM). If you do not wish to have dimming capability, please
move the switch to the "OFF" position (ON). [Refer to
diagram 2.]
Attach black faceplate to front of wall control; press down
firmly. [Refer to diagram 3.]
Align holes in wall control with posts located on inside of TOP
part of remote control cover and press together firmly. Place
wall control into BOTTOM part of remote control cover, aligning
posts in top of remote control cover with post holes in the
bottom. [Refer to diagram 3.]
(NOTE: Make sure to align narrower ends of remote control
cover before closing.) Squeeze top and bottom of remote
control cover together until you hear a click at each end,
indicating that the remote control cover has closed completely.
IMPORTANT: Store the handheld remote control away from
excess heat or humidity. To prevent damage to handheld
remote control, remove the battery if handheld remote
control will not be used for long periods.
NOTE
: Remove batteries with low or no charge and dispose
of properly.
CAUTION: “DO NOT DISPOSE OF BATTERIES IN FIRE, BATTERIES
MAY EXPLODE OR LEAK.” - When disposing of household
alkaline batteries, it is best to check with your local and state
recycling or household hazardous waste coordinators
concerning the specifics of the program in your area. You
may also locate a recycling center by calling 1-800-8-BATTERY
or 1-877-2-RECYCLE or visit www.epa.gov/epawaste/index.htm
or www.earth911.org for more information.
WARNING: Choking Hazard - Small parts. Keep batteries away
from children.
WARNING: Batteries are NOT rechargeable. Non-rechargeable
batteries are not to be recharged.
(top)
(bottom)
remote control cover
diagram 1
diagram 2
dimmer
switch
wall control
wire
wire
wire
12V battery
1
1
-
DIM ON
diagram 3
1
1
-
DIM ON
wall
control
face-
plate
remote control
cover, BOTTOM
post
hole
post
hole
remote
control
cover, TOP
nodule
