It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test wall control (optional
installation) by locating ON/OFF slider switch on
wall control, then set to the ON position. Test light
and dimmer function and then test fan speeds. Next,
locate handheld remote control. Test the light
ON/OFF function by pressing the L1 button; test
the dimmer function by pressing the L1 button and
holding it down for up to 5 seconds. Test fan speeds
with the different fan speed buttons. If the wall
and/or handheld remote control operate(s) all of the
functions of the fan and light, battery/batteries has
(have) been installed correctly. If the wall and/or
handheld remote control do (does) not operate all
of the fan/light functions, refer to "Troubleshooting"
section to solve any issues before contacting
Customer Service.
Turn fan completely off before moving the reverse
switch (located on top of motor housing). Set reverse
switch to recirculate air depending on the season:
- LEFT position in summer (diagram 1)
- RIGHT position in winter (diagram 2)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your comfort.
Important: Reverse switch must be set either
completely LEFT or completely RIGHT for fan to
function. If the reverse switch is set in the middle
position (diagram 3), fan will not operate.
NOTE: If the wall control/handheld remote control
interferes with other appliances, turn off power first
and then go back to the instructions in Section 11 on
the previous page .
14. Testing Your Fan.
motor
housing
reverse
switch
diagram 1
diagram 2
diagram 3
1
1
-
1
1
-
page 11
