8. Canopy Assembly.
9. Final Assembly.
Align hole in center of metal cover with threaded
rod located on the underside of motor housing.
Twist metal cover to the RIGHT (clockwise) until
metal cover locks into place.
Pull down VERY GENTLY on metal cover to make sure
that metal cover is secure.
page 9
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to lock.
Re-insert screw that was removed, and then tighten
both screws securely.
Slide canopy cover up to canopy.
Press up gently
but firmly on canopy cover until you hear it snap
onto the bottom of the canopy.
*Remember that antenna for remote control
receiver must rest
outside
of hanging bracket.
metal cover
motor
housing
threaded
rod
hanging bracket
screw
canopy cover
canopy
antenna
remote control
receiver
