page 7
WARNING
: Turn off circuit breakers to current fixture
from breaker panel and be sure switch is turned to the
OFF position.
CAUTION
:
Be sure outlet box is properly grounded and
that a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If
you are unfamiliar with electrical wiring or if the
house/building wires are different colors than those
referred to in the diagram to the right, please use a
qualified electrician.
When downrod is secured in place on the
hanging bracket, wire the receiver as follows:
Connect
3-WIRE PLUG
from fan to
3-WIRE PLUG
from remote control receiver. Make sure plugs snap
together completely.
Connect
BLACK
wire from remote control receiver to
BLACK
wire from ceiling with wire connector
provided.
Connect
WHITE
wire from remote control receiver to
WHITE
wire from ceiling with wire connector
provided.
Connect
GREEN
and
GREEN/YELLOW
wires from
remote control receiver to
BARE
/
GREEN
wire from
ceiling with wire connector provided.
Gently insert receiver (flat side up) into hanging
bracket and carefully push taped wire connectors into
outlet box. Let antenna rest outside of hanging
bracket.
PLEASE NOTE
: Wall and/or remote conrol must be
used for fan to operate. If you do not wish to use the
wall control, please proceed to Section 8 to continue
with fan installation.
IN ORDER TO WIRE WALL CONTROL
, remove existing
wall switch. Wire the
WALL CONTROL
with wire
connectors provided as shown in
diagram at right.
* Wrap each wire connector separately with electrical
tape as an extra safety measure. Gently push wires and
taped wire connectors into outlet box.
WARNING
:
CONNECT WIRES IN THE FOLLOWING
ORDER ONLY!
Connect
GREEN/YELLOW
ground wire to ground
from house or directly to one of the screws from the
outlet box. Connect one
BLACK
wire from wall control
to
BLACK
(hot) lead wire from house. Connect second
BLACK
wire from wall control to
BLACK
load wire to
fan.
Attach wall control to outlet box and secure with
screws from original wall switch. Attach front plate to
wall control using 2 screws provided in the wall
control.
6. Wiring.
black (OUT to fan)
green/yellow
black
(AC IN from
breaker box)
black
(TO POWER supply)
outlet box
wall
control
(wiring for wall control)
plate
1
2
3 4
5
6
green/
bare
ground
black
(wiring for receiver)
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
ground (green
or bare)
white supply wire
black supply wire
from receiver
black AC IN L
ground (green
or bare)
antenna
from ceiling
receiver
yellow
green/yellow
*
3-wire plug
white
from
receiver
green/yellow
AC IN N
from fan
