Step 4
Prior to securing mounting bracket, screw "J" hook (S10) into ceiling outlet
box as a secondary support means. Secure mounting bracket (#1) to the
outlet box (A) by tightening bracket screws & washers (S3) as shown. If
not mounting to an outlet box, use wood screws (S1) and washers (S3) and
mount securely to ceiling beam.
Be sure at this point to insert canopy
screws (S2) in bracket.
NOTE:
Do not mount directly to sheet rock or ceiling tile.
NOTE: J Hook installation is a Canadian requirement only.
4
OUTLET BOX
Outlet Box (A)
Mounting Bracket (1)
Bracket Screws
& Washers (S3)
Support Beam
Wood Screws (S1)
Canopy Screws (S2)
Ceiling
Wood Screws (S1)
“J” Hook (S10)
5
Step 5
Viewing fan housing and
motor from top, securely
plug the connector from the
wire harness into the wiring
harness connector (see diagram).
Locate the decorative rod
support bracket (A).
Using a decorative
rod (#7), insert wiring
harness (#11),
including
steel cable,
through
hole in support bracket (A)
and rod. Firmly hand
tighten rod into bracket
(rod must be fully seated
into bracket). Install remaining
two rods (#7) in support brackets
(B and C)and firmly hand tighten.
Fan Housing & Motor
Support Bracket (C)
Wire Harness (#11)
Decorative Rod (#7)
Support
Bracket (A)
Support
Bracket
(B)
Light
Socket
Step 1
Turn off circuit breakers and wall switch to the fan
supply line leads.
Warning:
Failure to disconnect power supply prior to
installation may result in serious injury or death. To reduce
the risk of shock, this fan must be installed with an isolating
wall control/switch.
1
Step 3
Check to make sure blades are at
least 30” from any obstruction.
Check downrod length to
ensure blades are at least
7' above the floor.
3
84”
(2.1m)
Min.
30”
0.75m
Min.
Preparation
Important:
When using an existing outlet box, be sure the box is securely attached
to the building structure and can support the full weight of the fan. Failure to do
so can result in serious injury or death.
Step 2
Determine mounting method to use.
A. Downrod Mount
B. Angle Mount
Craftmade Part #45AD (see dealer)
2
IMPORTANT:
If using the angle mount
method, check to make sure the ceiling angle
is not steeper than 35
°
. Angles greater than
35
°
will require a 45
°
angle adapter.
Downrod Installation
(Vaulted Ceilings)
Downrod Installation
(Normal Ceilings)
