6
Side View of Support Arm
Distributor Assembly (#8)
CAUTION:
Do not mount fan to sheet rock or
drywall type materials. To insure proper
support use the two #1 wood screws
to secure mounting bracket to joist or
beam, if the location you have chosen
does not have a suitable support beam,
install a 2" x 4" brace between ceiling
joists to support fan, or one of the
many NEC and UL approved ceiling
fan braces.
WARNING:
To reduce the risk of fire, electric shock or personal injury, mount to outlet box
marked "acceptable for fan support" and use mounting screws provided with the
outlet box. Most outlet boxes commonly used for the support of lighting fixtures
are not acceptable for fan support and may need to be replaced. Consult a qualified
electrician if in doubt.
Step 6
Insert wires,
including steel cable,
from top of support rod (#7) through
hole "A" in bottom of "support arm distributor" (#8). Insert ends of remaining
two rods into holes "B" and "C" in bottom of distributor. Place wires through
hex nut and tighten nut securely onto support rod. Use hex nuts to secure
remaining two rods into place. Insert wires through hole "D" and pull
through top of downrod section of distributor.
A
B
D
Downrod Section
Top View of Support
Arm Distributor (#8)
A
B
C
Wiring Harness
(including steel wire)
Hex Nut
Support Rod (#7)
8
Step 8
Position downrod so the hole in the downrod aligns with the hole in the
distributor assembly. Insert safety bolt (S10) through distributor assembly
and downrod and attach nut. Tighten firmly. Tighten set screw "A" against
downrod. Place distributor cover (#8a) over support arm distributor (#8).
Next place canopy (#3) over downrod assembly (#2). Replace hanging ball,
insert hanging pin through downrod and tighten set screw "C" in hanging
ball into downrod.
WARNING:
Failure to completely tighten downrod as described in steps 7 & 8 above could
result in the fan loosening and possibly falling.
Ground
Wire
Ball
Screw
Hanging
Pin
Hanging
Ball
Threaded
Set Screw Hole
Safety Bolt
and Nut
Set Screw (A)
Canopy (3)
Distributor
Assembly (2)
Set Screw (C)
Downrod (2)
Distributor
Cover (8a)
Hanging Ball
Lock Pin
Support Arm
Distributor
Assembly (#8)
Downrod
Ball Screw
Green Ground
Wire
Downrod
Assembly
(#2)
Step 7
Locate downrod assembly (#2).
Loosen ball screw on black hanging
ball to free lock pin. Black hanging
ball will slide down. Remove ground
screw and green ground wire.
Remove hanging ball from downrod
and save all parts. Insert wires
and
steel cable
from distributor assembly
through downrod. Screw downrod
into top of Support Arm Distributor
Assembly (#8), being careful that
wires are pulled through.
7
