page 7
It is recommended that you test fan before
finalizing installation. Restore power from
circuit box and light switch (if applicable). Test
fan speeds with the pull chain labeled FAN.
Start at the OFF position (no blade
movement). First pull will set the fan to HI.
Second pull will set the fan to MEDIUM. Third
pull will set the fan to LOW. Fourth pull will
again set the fan to the OFF setting. Test light
with the pull chain labeled LIGHT. (
diagram 1
)
If fan and/or light do (does) not function,
please refer to "Troubleshooting" section to
solve any issues before contacting Customer
Service.
Turn fan completely off
before
moving the
reverse switch. Set reverse switch to
recirculate air depending on the season:
- LEFT position in summer (
diagram 2
)
- RIGHT position in winter (
diagram 3
)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important
: Reverse switch must be set either
completely to the LEFT
or
completely to the
RIGHT
for fan to function. If the reverse switch
is set in the
middle
position (
diagram 4
), fan
will not operate.
Attach pull chain extensions supplied or
custom pull chain extensions (sold separately)
to the end of the pull chains.
10. Testing Your Fan.
9. Light Kit Assembly.
Partially loosen 3 thumbscrews at bottom
of motor housing and raise glass shade to
motor housing. Secure glass shade with
thumbscrews.
NOTE
: Be sure thumbscrews make contact
with rubber ring on glass shade
but DO NOT
overtighten thumbscrews as glass may crack
or break
.
diagram 2
diagram 3
diagram 4
glass
shade
rubber ring
thumbscrew
reverse switch
motor
housing
light
pull chain
extension
fan
pull chain
extension
diagram 1
