page 6
7. Fan Assembly.
Remove motor housing from j-hook on
mounting plate. Lift motor housing to mounting
plate. Align slotted holes on top rim of motor
housing with loosened screws in mounting
plate. Twist motor housing to lock. Re-insert the
2 screws that were previously removed (page 4,
Section 4) and then tighten all 4 screws to secure
motor housing.
Locate 4 tabs
inside
housing ring with wider
opening facing up (toward ceiling), place
housing ring over motor housing and raise to
ceiling, aligning tabs in housing ring with 4
screws at top of motor housing. The tabs must fit
snugly
over
the screwheads to ensure a secure
fit.
NOTE
: It is recommended to push one tab on
at a time instead of doing all four at once.
motor
housing
mounting plate
j-hook
housing ring
slotted hole
tab
6. Wiring. (cont.)
[
PLEASE NOTE
: Wall and/or handheld remote
control must be used for fan to operate.
If you do
not
wish to use the wall control, please proceed to
Section 7 below to continue with fan installation.
]
To install wall control
, remove existing wall
switch. Wire one of the wall controls with wire
connectors provided
as shown in diagram at
right
.
*Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
Install one 12-volt battery (included) in wall
control.
IMPORTANT
: Wall control will not function unless
battery is installed.
WARNING
: Battery is to be inserted with the
correct polarity.
Since this fan comes with an LED light kit, the
dimmer switch (labeled
DIM
and
ON
) has been
pre-set to the "ON" position (
DIM
). If you do not
wish to have dimming capability, please move
the switch to the "OFF" position (
ON
).
Select a faceplate (almond or white) and press
firmly onto front of wall control. Attach wall
control to outlet box and secure with screws from
original wall switch. Attach wall plate (included) to
wall control using 2 screws provided with the wall
control.
(wiring for wall control)
black (OUT to fan)
green
black
(AC IN from
breaker box)
black
(TO POWER supply)
black
green/
green/
bare
bare
ground
ground
green/
bare
ground
outlet box
wall control
face-
plate
12V battery
dimmer
switch
wall plate
DIM ON
