6
Step 6
Position downrod so the hole in the downrod aligns with the hole in the
coupling on the motor. Insert safety bolt (S7) through coupling and
downrod and attach nut. Tighten firmly. Tighten set screw "A" against
downrod. Place flange cover (#4) over downrod assembly until it covers
flange. Place canopy (3) over downrod (#2). Replace hanging ball, insert
hanging pin through downrod and tighten set screw "C" in hanging ball
into downrod.
WARNING:
Failure to
completely tighten
downrod as described in
steps 5 & 6 above could
result in the fan loosening
and possibly falling.
Safety Bolt
and Nut
Set Screw (A)
Canopy (3)
Motor Housing (5)
Set Screw (C)
Downrod (2)
Flange Cover (#4)
Ground
Wire
Ball
Screw
Hanging
Pin
Hanging
Ball
Threaded Set
Screw Hole
7
Step 7
For added security, attach safety cable from fan unit to "J" hook (S10) in
outlet box. Secure by looping zip tie (S11) through safety cable and "J"
hook. Tighten zip tie securely. Lift fan onto the mounting bracket (#1).
Turn housing until hanging ball seats itself into ball socket (listen for
click).
NOTE
: Parts furnished will allow
you to install your fan at up to a
35° angle. Angles greater than 35°
will require a 45° angle adapter (see
dealer).
NOTE
: J Hook
installation is a Canadian
requirement only.
Outlet Box (A)
Support Beam
Ceiling
Green Ground Wire
“J” Hook (S10)
OUTLET BOX
“J” Hook (S10)
Safety Cable
Zip Tie (S11)
Mounting Bracket (#1)
WARNING:
To reduce the risk of fire, electric shock or personal injury, mount
so outlet box marked "acceptable for fan support" and use mounting screws
provided with the outlet box. Most outlet boxes commonly used for the support
of lighting fixtures are not acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
