4. Hanging Bracket Installation.
page 3
ON
OFF
ON
OFF
3. Installation Preparation.
hanging bracket
10 feet
(3.05m) (76cm)
30
inches
12f
t.
- 20f
t.
12ft. - 20ft.
(3.66m - 6.1m)
(3.66m - 6.1m)
blade edge
Turn off circuit breakers to current fixture from
breaker panel and be sure operating light switch is
turned to the OFF position.
WARNING:
Failure to disconnect power supply prior
to installation may result in serious injury.
Remove existing fixture.
WARNING:
When using an existing outlet box, be
sure the outlet box is securely attached to the building
structure and can support the full weight of the fan.
Ensure outlet box is clearly marked "Suitable for Fan
Support." If not, it must be replaced with an approved
outlet box. Failure to do so can result in serious injury.
CAUTION
:
Be sure outlet box is grounded properly
and that a ground wire (
GREEN
or bare) is present.
Install hanging bracket to outlet box using original
screws, spring washers and flat washers provided
with new or original outlet box.
*
Arrange electrical
wiring around the back of the hanging bracket and
away from the hanging bracket opening.
*Note
: It is very important that you use the proper
hardware when installing the hanging bracket as this
will support the fan.
To prevent personal injury and damage, ensure
that the hanging location allows the blades a
clearance of 10 feet (3.05m) from the floor and
30in. (76 cm) from any wall or obstruction.
This fan is suitable for room sizes up to
400 square feet (37.2 square meters).
Installation requires these tools:
Phillips screwdriver, flathead screwdriver,
adjustable pliers or wrench, stepladder, wire
cutters, and rated electrical tape
spring washers
outlet box screws
flat washers
This fan can be mounted with a
downrod
on a
regular (no-slope) ceiling
only
. Fan
CANNOT
mount as a flushmount installation
nor
on a
vaulted ceiling.
downrod
installation
CANNOT be
installed on
angled or
vaulted ceilings
flushmount
installation
