page 7
10. Light Kit Assembly (Optional).
NOTE
: If you do
not
wish to use the light
kit, you may proceed to Section 11 on
page 9 to complete installation.
If you wish to use your fan
WITH
the
light kit
, remove 3 screws from switch
housing and remove switch housing
cap from switch housing.
Locate
BLUE
(or
BLACK
) and
WHITE
wires in switch housing labeled FOR
LIGHT. Remove and discard plastic
that holds these 2 wires together.
Remove wire connectors from these
same wires as well--
save wire
connectors for later use.
Punch center cap out of switch
housing cap with a screwdriver.
["Light Kit Assembly" continued on
next page.]
9. Blade Attachment.
switch housing
motor housing
white wire
blue (or black)
wire
wire connectors
center cap
switch housing
cap
y-connect
blade
assembly
piece
blade arm
blade
Align the 3 holes in the blade with the
3 blade screws pre-installed on the
blade arm. Press down on the blade
firmly enough so that the blade screws
come through the holes in the blade.
[
CAUTION
: Be careful not to use so much
force that the blade arm bends.
]
Hold the y-connect blade assembly
piece so narrower end faces toward the
part of the blade with the holes (
as
shown in drawing at right
) and then place
the y-connect blade assembly piece on
the top side of the blade.
[
Please note
the side of the y-connect blade
assembly piece indicating THIS SIDE
UP.
]
Slide y-connect blade assembly
piece onto the blade screw at the end of
the blade. Rotate y-connect blade
assembly piece
counterclockwise
to lock
into place.
Repeat Section 9 for each blade.
blade
screw
