Craftex TENONING JIG, Руководство пользователя, Страница: 9 / 16

9
Fig. 13
6. Loosen two lock handles (N) and (P) and move the
Jig until the vertical work support plate (F) is
against the saw blade and tighten lock handle (N).
NOTE: The lock handles (N) and (P) are spring-
loaded and can be repositioned by pulling out on
the handle and rotating the handle clockwise or
counterclockwise. See Figure 13 .
7. Check if the vertical support plate (F) is parallel to
the saw blade. See Figure 13 .
8. If an adjustment is necessary, Loosen lock handles
(N) and (P).
9. Loosen setscrew (T) and remove the micro-adjust-
ment assembly from Tenoning jig.
10. Align the two holes (U) in the jig with the two
screws (not shown) in the guide bar (X).
11. Loosen two guide bar screws inside holes (U) and
move jig until vertical work support plate (F) is
parallel with the saw blade.
12. Tighten the two guide bar screws inside holes (U).
13. Reinstall the micro-adjustment assembly and
tighten setscrew (T). See Figure 13 .
14. Move vertical work support plate (F) 1/8” away from
saw blade; tighten lock handle (N). See Figure 13 .
15. Loosen screw (Y) and adjust pointer (Z) to the
1/8” mark on the scale. Retighten screw (Y). See
Figure 13 .
16. Turn screw (M) clockwise until it bottoms. This
prevents the vertical work support plate (F) from
accidentally being moved into the saw blade;
tighten nut (L). See Figure 12 .
F
P T
Z
Y
X
U
N
U
ADJUSTMENTS
DISCONNECT SAW FROM THE POWER SOURCE.
1. For rapid adjustment of the vertical work support
plate (A) toward or away from the saw blade (G),
loosen lock handle (B) and (C) and move Jig (D)
as necessary. Tighten lock handles after rapid
adjustments are made. See Figure 14 .
2. Fine adjustments of the vertical work support plate
(A) can be accomplished by loosening lock handle
(B) and rotate knob (E) until plate (A) is at the
desired position. Tighten lock handle (B) after fine
adjustments are made. See Figure 14 .
3. To tilt the vertical work support plate (A), loosen
lock handle (F), tilt vertical work support plate (A)
to the desired angle and tighten lock handle.
See Figure 14 .
4. To cut an angle tenon, loosen lock handle (H) and
adjust backstop (J) to desired angle and tighten
lock handle.
5. IMPORTANT: The Tenoning Jig is not equipped
with a bevel scale for the positioning of the back-
stop (J) or vertical work support plate (A). The
desired angle of the workpiece should be cut prior
to set up of the Tenoning Jig.
A
J
H
G
D
F
E
C
B
Fig. 14
WARNING
!
WARNING
!
This jig should only be used with suitable tablesaws.
Please refer to your tablesaw’s manual for further
information. All tablesaw safety features and guards
must be kept in place and in good working order
during the use of this jig.