2
Warning
PRODUCT SPECIFICATIONS
Tenoning Jig
•
Fits left and right tilting table saws with 3/8” deep x
3/4” wide miter gage grooves. Left tilt application
requires some assembly.
•
Handles stock up to 3-1/4” thick.
•
Adjustable guide bar to better-fit miter gage groove.
•
Two large grip-feed handles.
•
Multi-position control levers.
•
Adjustable bevel-angle 90 to 45 degrees.
•
Adjustable backstop 90 to 45 degrees, with adjustable
90 degree positive-stop.
•
Extra large clamp hand-wheel.
SAFETY INSTRUCTIONS
GENERAL SAFETY INSTRUCTIONS
Operating a Tenoning Jig and Table Saw can be dan-
gerous if safety and common sense are ignored. The
operator must be familiar with the operation of the tool.
Read this manual to understand this Tenoning Jig.
DO
NOT
operate this Tenoning Jig if you do not fully under-
stand the limitations of this tool.
DO NOT
modify this
Tenoning Jig in any way.
REMEMBER:
Your personal
safety is your responsibility.
BEFORE USING THE TENONING JIG
To avoid serious injury and damage to the tool, read
and follow all of the Safety and Operating Instructions
before operating the Tenoning Jig.
1.
READ
the entire Owner’s Manual.
LEARN
how to
use the tool for its intended applications.
2.
AVOID A DANGEROUS WORKING ENVIRON-
MENT. DO NOT
use electrical tools in a damp
environment or expose them to rain.
3.
DO NOT
use electrical tools in the presence of
flammable liquids or gases.
4.
ALWAYS
keep the work area clean, well it, and
organized.
DO NOT
work in an environment with
floor surfaces that are slippery from debris, grease,
and wax.
WARNING
!
This jig should only be used with suitable tablesaws. Please refer to your tablesaw’s manual
for further information. All tablesaw safety features and guards must be kept in place and in
good working order during the use of this jig.