Craftex CX509, Руководство пользователя

Страница: 9 / 23

9
TEST RUN
Once you have assembled your sander
completely, it is then time for a test run to
make sure that the machine works properly
and is ready for operation.
During the test run if there is any unusual
noise coming from the machine or the
machine vibrates excessively, stop the
machine immediately and disconnect from
the power source. Investigate to find out the
problem with your machine.
TO TEST RUN THE CX509:
1. Make sure you have read the manual
and understood all the safety
instructions given in it.
2. Remove all the tools and objects from
the machine, used during set up and
assembly.
3. Make sure the sanding drum is safely
above the conveyor belt so that it will
not make contact when running.
4. Connect the power cord to the matched
outlet and push the ON button.
5. Let the sander run for a minute and then
turn the switch OFF.
ADJUSTMENTS
The adjustments below have already been
performed at the factory prior to shipping.
However, during shipping some parts might
get out of adjustment, and we recommend
you to at least verify the following
adjustments to ensure the best possible
results from your sander.

Feed Belt Tensioning and Tracking
(page-14)

V-Belt Tensioning (page-16)
WARNING!
Before the test run make sure the switch
is in the OFF position and the cord is
disconnected from the power source.
Failure to do so, could result in serious
personal injury.