Craftex CX507, Руководство пользователя

Страница: 14 / 23

14
Tighten conveyor table mounting bolts.
Recheck the measurement at A and at B.
Test sand a piece of wood and check for
uniform thickness.
If the measurement at A exceeds B by
more than .020”, or if distance B is greater
than A, proceed as follows:
Loosen the two front and two rear
adjustment bolts as shown, thus allowing
the entire drum assembly to pivot.
If the sander is mounted to a stand or
bench, loosen the mounting bolts on the
motor end.
Using the height adjustment hand wheel,
lower the drum until the distances at "A"
and "B" are equal. Tighten the alignment
bolts and the mounting bolts.
Test sand a piece of wood and check for
uniform thickness. Repeat the above
procedure if necessary.
CONVEYOR BELT
REPLACEMENT
The conveyor belt on the CX507 will get old
with use and will need a replacement.
TO REPLACE THE BELT
Make sure the cord is disconnected from
the power source.
Raise the sanding drum to its highest
position using the height adjustment hand
wheel.
Remove the two screws and star washers
securing the front nip guard to the variable
speed control box using phillips type
screwdriver.
Remove the two conveyor table mounting
bolts on the outboard, open side of the
drum sander using the 6mm hex wrench
provided.
Reduce the tension on the conveyor belt by
rotating the inboard and outboard conveyor
belt tracking adjustment screws
counterclockwise.
Hold the conveyor belt from both sides and
gently lift conveyor table, sliding the belt off.
If the belt does not remove, loosen the
tension a little more on the conveyor belt.
Now lift the table high enough and slide off
the belt.
Slide the new conveyor belt onto the rollers
and tension the conveyor belt.
Reinstall the conveyor table mounting bolts
and the nip guard and secure them
properly.