Craftex CX503, Руководство пользователя

Страница: 13 / 18

13
BELT REPLACEMENT
The sanding belt must be checked regularly
and replaced if it is old or damaged.
To replace the sanding belt:
Make sure the switch is in the OFF position
and the cord is disconnected from the
power source.
Open the belt guard securing knob shown
in figure-14.
Figure-14 Removing the belt cover
Remove the two knobs securing the side
cover shown in figure-15 and open the side
cover.
Figure-15 Opening the side cover
Loosen the tension on the belt by pulling
out the belt tension lever shown in figure-
16.
Figure-16 Releasing the belt tension
Once the tension is released on the
sanding belt, remove the sanding belt and
replace it with a new one. Observe the
proper direction when installing belt.
Tension the belt using the belt tension lever
and close the side cover and the belt guard
securing with the knobs.
After installing a new sanding belt, check
tracking and ensure the belt is tracking
properly.
WARNING
Do not make any adjustments while the
machine is running. Turn the machine
OFF and un-plug the cord from the
power source before making any
adjustments or cleaning. Failure to do so
may cause serious personal injury.