Craftex CX212, Руководство пользователя

Страница: 15 / 29

15
MAIN TABLE TO BLADE
PARALLELISM
Your CX212 will give a better result if the
main table is parallel to the blade. If it is not
parallel, the result you will get will be poor
and low quality.
To check if the table is parallel to the blade,
use an adjustable square and measure the
distance between the miter slot on the table
and the edge of the blade (front or back) as
shown in figure-18.
Figure-18 Measuring the distance using an
adjustable square
Now, lock the square in place and mark the
blade with a marker where you made the
measurement. Rotate the blade so that the
mark is opposite to the first position (front or
back) and slide the square to check if the
blade is at the same distance with the miter
slot.
The measurement should be equal on both
sides. If the measurements are not the
same, the table needs to be adjusted
parallel to the blade.
TO ADJUST THE TABLE
Make sure the switch is in the “OFF”
position and the cord is unplugged from the
power source.
Loosen the four mounting bolts (under the
table) securing the table on the cabinet and
adjust the table to get equal measurements
on both sides of the blade. Once the table
is parallel to the blade, retighten the
mounting bolts.
TENSIONING THE V-BELT
The belt stretches with use and needs to be
checked and tensioned properly as the
table saw is used.
Remove the cord from the power source.
Raise the blade to two inches above the
table and open the motor cover. Loosen the
hex nuts securing the motor as shown in
figure-19 and move the motor slightly up
and down.
Figure-19 Belt tensioning hex bolt
Check the tension on the V-belt and press
the motor down to tension the belt.