41
4. Repeat steps 2 and 3 for the leftmost roller segment and the roller spring tensioning screw on the left side
plate.
5.4.14 Auto Alignment Gate Travel
1. Raise the
gate by pressing 9 4 7 FUNCT
A.
2. Press FUNCT to adjust the gate height. The gate fingers should be as close as possible (within 0.02” or
0.5mm) to the input guide without touching it. Each press of
A will slightly raise the gate and each press
of
B will slightly lower the gate. When the gate is at the correct height, press ENTER.
3. Press
B to lower the gate to its deactivated position and then press
A to check for correct activated gate
height. Press CLEAR to exit the test. Recheck by repeating step 1.
5.4.15 Auto Alignment Skew Sensor Calibration
1. Press 9 4 6 FUNCT to display “Skew Calibration”.
2. Insert a document with known square top and left edges. If the document inserts straight and its top edge is
perfectly parallel to the input guide edge, press ENTER to calibrate the skew sensors and exit. If the
document did not insert perfectly, press EJECT and insert again.
5.4.16 DP7 Carriage Spring
The spring between the box and the right pivot arm reduces the carriage force against the platen, minimizing
picking of document edges and slider wear. To adjust spring tension rotate the spring hooks. Tension should
be set as high as possible without causing lighter print near the edges of thick documents.
Roller Segments
Roller Shaft
Input Guide
Gate fingers
