CR Laser SUPER-3S, Руководство пользователя

Страница: 12 / 16

Laser Show System
7.4 DMX OPERATED MODE:
The DMX-protocol is a widely used high speed signal to control intelligent light
equipment. You need to “daisy chain” your DMX controller and all the connected
light effects with a good quality XLR M/F balanced cable.
Each effect in the chain needs to have its proper staring address so it knows
which commands from the controller it has to decode.
This is how you must setup and use the fixture:
z
Connect the unit to a DMX-controller using a suitable DMX-cable.
z
Determine which DMX address the laser needs.
z
Set DIP-switch number 10 in “DMX” position.
z
You will have to set the DMX staring address with the DIP-switches 1to 8. Each
of these switches has a corresponding DMX-value written under it. You can
combine the values of these switches to obtain any staring address between
001 and 256:
z
The display helps you check if the desired staring address is correct.
z
Once the address is set you can switch the unit on with the key actuated on/off
switch.
7.5 ILDA CONTROL MODE:
This unit has the ILDA DB25 port, and it can be controlled by the PC, There
is auto transform set in the inside of the unit to transform the ILDA and the
preprogram. when connecting by the 25 pin cable, the unit will be control by PC,
when disconnect the unit, it will be preprogrammed program control
。
In the theory, as long as it is ILDA B25
，
It can control this unit, but in the reality,
some of the software can not control this unit, for the 4 pin and the 17 pin of the
output card has not connect. In fact this is an easy problem. As long as you
connect them. It can control this unit.
11