CPI T02KO, Руководство по установке и эксплуатации

Страница: 39 / 122

KA BAND OUTDOOR TWT AMPLIFIER
P
□
UNITS
□
BUZZER
□
DISPLAY
□
IP CONFIG
□
CIF PORT
□
VERSION
3.3.2 Control Keys
The Remote Control Unit Control Keys are functionally grouped as described in Table 3-2. These
keys are shown in Figure 3-3.
Table 3-2. Front Panel Control Keys
Key Description
CONTROL Sets the control point for the amplifier. Toggles between Local, Serial and
Ethernet.
In local mode the LCL LED will be lit and only the RCU can control the
amplifiers. An M&C system can still query on the Serial or Ethernet ports.
In Serial or Ethernet mode the M&C LED will be lit and only the Serial or
the Ethernet port can control the amplifiers. The RCU can still query the
amplifiers.
SYSTEM
If a switch system is detected (1:1, 1:1 Power Combined, 1:2):
1
st
press: Switch system status screen
2
nd
press: Switch system configuration screen
AMP
Shows the amplifier status screen. When several amplifiers are connected,
use LEFT / RIGHT keys to switch amplifier as indicated by the amplifier
number on the left-hand side of the display.
TRANSMIT If the RCU control point is local, a transmit command will be sent to the
amplifier.
STANDBY
If the RCU control point is local, a standby command will be sent to the
amplifier.
RF INHIBIT
Sets / Resets the RF Inhibit state of the Amplifier.
RESET Resets the fault state of the Amplifier.
MENU Displays the menu selections for the amplifier. Repeat pressing the key to
show the menu for other amplifiers or to set RCU configuration
(P shown on the left hand side of the display).
SET PWR Displays the output power and attenuation set points of the amplifier.
D
OC
.01031492 R
EV
.3
3-7