CPI T02KO, Руководство по установке и эксплуатации

Страница: 36 / 122

KA BAND OUTDOOR TWT AMPLIFIER
3-4
3.3 Optional RCU Controls and Indicators
The Rack Mount Remote Control Unit is normally operated in the REMOTE mode via the one of
three serial interface types connected to an M&C system (via LAN for Ethernet).
The front and rear panels of the Remote Control Unit are shown in Figure 3-2. Firmware Updates
are discussed in Multi-drop operation, section 3.3.1, see below.
Refer to the Rack Mount Remote Controller I&O manual,
01032319 for the detailed information.
AMP
SYSTEM
LCL
M&C
RESET
M ENU
FAULT
J6 100-240VAC 1A 50-60HZ
J5 RS-232
RS-485
RS-232
FROM M&C
J4 RS-232 / RS-485
J3 CAN BUS
J2 10BASE-T
LAN LINK
J1 RS-485 TO PA
Figure 3-2. Remote Control Unit Front and Rear Panels
The AC Power switch is on the left end of the rear panel. The power required is 100 – 240V
AC
47/63 Hz, single phase, < 10Watts.
3.3.1 Multi-Drop Operation
Multi-Drop Functionality can control up to 10 units of the same type (types cannot be mixed) or a
Single Switch System (1:1, 1:1 Power Combined, 1:2). After installation, the first step is to assign
amplifier addresses.
3.3.3.1 Amplifier Address Assignment
The Remote Panel has a built-in utility to easily change the address (from 48 to 111) of the units to
be connected together in any of the above modes. In order to assign an address, only one unit can
be operational at a time. All other amplifiers
must be powered off .
For simplification of this section, key-in commands will be in Italics and items shown in the
display will be in Bold .
1. After the first unit is powered up, press the MENU key until P is displayed at the left end of
screen. Use the arrow keys to highlight CIF Ports box then press ENTER key twice.
2. Use the up / down keys to highlight AMPLIFIER ADDRESS RESCAN: NO . Press the up arrow
to change the display from NO to YES then press ENTER . The RCU will restart and rescan.
Only one amplifier should be found.
INSTALLATION AND OPERATION MANUAL