CPI Confidential V 11
June 12, 2009
8
If the channel changer achieves this faultlessly, run the KPA down and rebuild using the
reverse steps of the process detailed previously.
If the channel changer gets stuck at any point, or errors are reported on “FELIX”, repeat
the cleaning and lubrication procedure and retest.
Note:
As a guideline, travel from Channel 1 to 50 should take about 12 seconds with well
functioning channel changers. Channel change faults will not be shown on the KPA until
this time exceeds 30 seconds. The “HOME” process will take longer than 30 seconds but
only happens when KPA is powered on.
