CPI Confidential V 11
June 12, 2009
2
Procedure
The channel changer controller assembly needs to be removed. This is done by
disconnecting the control cable from the D15 connector (already removed and not shown
in the above picture), loosening the four thumbscrews locating on the side mounting
plates, and then disconnecting and removing the channel changer controller (caution: care
must be taken as you remove the channel change controller because a D50 connector
exists between it and the motor module) from the motor module.
Channel changer
controller assembly
D15 connector
Thumbscrews - two on each
side of controller bracket
mounting plates
Motor
Module
