Coyote C Series, Инструкция по использованию и уходу

Страница: 28 / 46

27
How to Remove Scratches from your Stainless Steel:
If your situation is a little more serious and you have obtained scratches in your equipment, then you will need
to purchase a third-party stainless steel scratch kit. These kits are popular in retail stores but can be easier to
obtain online. With these kits, you will not polish the unit until you are done re-scratching the entire product
you are working on. With a scratch kit, the goal is to literally re-scratch the entire surface, so that the original
grains are replaced by your new scratched-in grains. With this practice, you must be willing to treat the entire
surface or you will notice a start and stop point. Also, be careful to pay attention to your rolled or finished edges
as these scratch kits will ruin this finish. After you have used the kit, you will want to follow it up with a good
stainless polish (as mentioned prior) and then a dry towel for a final wipe down. Follow all directions on any
third-party stainless steel scratch kits. Coyote does not insure or guarantee the performance of or results from
such products.
HOW TO CHANGE THE LIGHT BULBS
1. Remove the screw holding the bulb lens.
2. Reach in using your fingers only, grip the two outside edges of the light bulb. Do not grip the top or bottom
of the bulb, as it might break. Pull the bulb straight out, so that the two electrode wires are completely
removed with bulb. Place bulb in trash.
3. When installing the new halogen bulb be sure to use a clean cloth or paper towel to ensure the longevity of
the bulb.
4. Insert the new bulb using your clean cloth and gently snap it into position. Wipe off any fingerprints and/or
grease that may have transferred to the bulb.
5. Re-install the bulb lens and cover
6. Flip the switch on to check lights.
ANNUAL CLEANING OF GRILL HOUSING
Burn-off of the barbecue after every cookout will keep it ready for its next use. However, once a year, you
should give the entire grill a thorough cleaning to keep it in top operating condition.
1. Allow grill to cool down completely. Shut off gas supply at source and disconnect fuel line. Protect fuel
line fitting.
2. Remove and clean the cooking grids, heat control grids and burners.
3. Remove warming rack and wash with mild detergent and warm water.
4. Cover the gas valve orifices with a piece of aluminum foil.
5. Brush the inside and bottom of the grill with a stiff wire brush, and wash down with a mild soap and warm
water solution. Wash thoroughly and let dry.
6. Remove aluminum foil from orifices and check orifices for obstruction.
7. Check electrode to make sure that a spark is being generated.
8. Reinstall heat control grids, cooking grids, and warming rack.
9. Reconnect to gas source and observe burner flame for correct operation.
IMPORTANT:
You should NOT line the bottom of the grill housing with aluminum foil, sand or any other grease
absorbent substance. Grease will not be able to drip into the drip tray and a grease fire may occur.
MAINTENANCE GUIDELINES
1. Keep outdoor cooking gas appliance area clear and free from combustible materials, gasoline and other
flammable vapors and liquids.
2. Do not obstruct the flow of combustion and ventilation air.