cowfish VanTenna, Руководство пользователя и инструкция по установке, Страница: 8 / 19

To mount the VanTenna unit complete the following steps:
1. Check with your caravan manufacturer to determine what type of screws
are suitable for your roof.
2. After selecting a suitable location on the roof of the caravan for the
VanTenna, drill a 20mm hole (at minimum) for two coax cables. One coax
cable is for the television signal (supplied) and the second coax cable is
for the FM signal (not supplied).
3. Run the TV coax cables from the VanTenna location to the wall plate /
power supply.
4. (Optional) Run the AM/FM coax cable to your AM/FM unit.
5. Connect the coax cables to the VanTenna unit.
6. Clean the roof at the location of installation and ensure that the area is
dry. This will allow for better adhesion of the sealing compound and will
prevent leaks.
7. Place the VanTenna at the selected location, ensuring that that cables
freely move into the roof cavity and that the hole in the base of the
VanTenna aligns with the hole in the roof of the caravan. Failure to align
these hole will cause damage to your coax cables and potential leaks.
8. Lift up the VanTenna and apply a liberal amount of approved non-
hardening sealing compound on the bottom of the VanTenna and place
the VanTenna on the roof. Ensure that that the hole on the VanTenna
base is aligned to the hole in the roof.
9. Secure the VanTenna to the roof with four screws.
10. Run a solid bead of sealant over the mounting screws and around the
perimeter of the VenTenna base. This will help to prevent leaks.
Page 8