Coway BA35-A, Руководство пользователя

Страница: 22 / 28

TROUBLESHOOTING
The bidet may operate abnormally due to minor causes not because of a product malfunction but
because the user is unfamiliar with using the product. In such a case, problems can be easily solved even
without the help of the Service Center by checking the following. If you cannot solve the problem after
checking the following items, please call the Service Center.
Symptom Check Solution
The product is not
functioning at all.
• Is the low battery LED flashing? Replace the new battery.
• Is the battery inserted normally? Please check the insertion positions (+,-).
• Is the seat sensor working properly? Refer to seat sensor instructions. (see page 11)
There is no water
coming out of the
nozzle.
• Is the main water supply valve closed? Open the main water supply valve.
• Is the nozzle clogged? Unclog the nozzle using a brush.
• The bidet has been installed, but there’s no
water coming out of the nozzle.
Check if your water has been shut off. Check
if the handle valve is in the locked position.
The water pressure is
too low.
• Is the water pressure setting too low? Adjust the water pressure setting.
• Is the nozzle clogged? Unclog the nozzle using a brush.
• Is the water supply mesh filter dirty? Clean the mesh filter. (see page 17)
Water continues to
come out after stop is
pressed.
• Water is leaking from the bidet hose. Push the bidet hose all the way in.
Water is leaking, but
not from the nozzle.
• Water is used to clean the nozzle after cleansing. This is not a malfunction.
• Water beads can sometimes form around the nozzle.
Water beads formed at the bottom of the product after cleaning the nozzle may drip
into the bowl. This is not a malfunction.
The buttons are not
responding.
• Are you seated on the bidet?
The bidet’s features are only active when
there is a person seated on the bidet.
• Is the handle valve located on the side of the
bidet in the released position?
If the handle valve is in the locked position,
the nozzle will not extend.