Squaring and Anchoring Frame
TO PREVENT SERIOUS INJURY: Contact local utility companies to ensure that installation area is free of
pipes, cables, and other hazards BEFORE installing Anchors or choosing installation area.
1. Position Frame in desired in location. The location must be flat, level,
and stable with good locations for the Anchors (15).
2. Level the Frame end-to-end and side-to-side.
3. Measure width of Frame at front and back. It should be 12 ft. wide at front, back, and center.
4. Take diagonal measurements (A and B) as shown in Figure G. When these two measurements
are equal, the Frame is square. Adjust the Frame until A and B are equal to within 1 inch.
5. Once diagonal measurements are equal, check the width again to ensure all widths are equal at 12 ft.
Note:
If measurements cannot be made correct, then parts may not be seated together properly.
11' 10"
20'
B
A
Figure G: Verify and Adjust for Frame Squareness
11' 10"
Page 8
For technical questions, please call 1-888-866-5797.
Item 58741
SAFETY
O
PERA
TION
M
AINTENANCE
SETUP
