1. Assemble roof ridge using five Ridge Tubes (4) with 4-Way Peak Connectors (7) between
them, and a 3-Way Peak Connector (11) on each end. The Ridge Tubes connect to
the straight ends of the Connectors and the curved, free ends of the Connectors angle
down, as shown in Figure C. Align holes in Ridge Tubes and Connectors.
a. Insert two M6 x 50 Bolts (18), Washers (20) and Nuts (21) at each 4-Way connection.
b. Insert one M6 x 50 Bolts (18), Washers (20) and Nuts (21) at each 3-Way connection.
c. Only finger-tighten nuts at this time.
2. Connect a Rafter Tube (3) to each free end of every 4-Way Peak Connector (7) and 3-Way Peak Connector (11)
on each side.
11
3
7
3
7
7
4
3
3
3
4
3
3
4
3
3
3
11
3
4
7
4
3
4
3
3
11
18
20
21
3
7
18
4
3
4
20
21
20
21
Figure C: Ridge and Rafter Assembly
3. Assemble five Roof Shoulder Tubes (4-1) using 4-Way Side Connectors (10) between them, with Left 3-Way
Side Connector (8) on one end and Right 3-Way Side Connector (9) on the opposite end (see Figure D).
The Roof Shoulder Tubes connect to the straight ends of the Connectors, and the curved ends of
all Connectors must face up and angled the same direction, as shown. If that is not the
case, the wrong connectors were used, or they were assembled backwards.
4. Assemble an identical Roof Shoulder group by repeating the instructions in the step above.
9
8
4-1
4-1
4-1
4-1
4-1
10
10
10
10
Figure D: Roof Shoulder Assembly
5. Connect the Roof Shoulder assemblies to the ends of the Rafters, as shown in Figure E.
Figure E: Roof Frame Completion
6. Make sure all parts assembled up to this point are firmly joined together.
Tap parts together gently with a rubber mallet (sold separately) if needed.
7. Fully tighten all nuts on the Roof Frame assembly with a wrench (sold separately).
Page 6
For technical questions, please call 1-888-866-5797.
Item 58741
SAFETY
O
PERA
TION
M
AINTENANCE
SETUP
