Note:
The labeled arrow marks on the rear cross
brace (#5) should be facing upwards.
Step 3:
Fasten the
top cross beam w/adjustable teeth
(#1) to the
front and the rear upright supports
(#2 and #3) by using bolts (#15), washers (#20),
and steel nuts (#25). Repeat the same
procedure for both sides. See Fig. A – Step 3.
Step 5:
Fasten the rear cross brace (#5) to the rear
upright supports (#3) by using bolts (#17),
washers (#21), and plastic nuts (#26). Tighten
all of the plastic nuts and bolts.
See Fig. A – Step 5.
PAGE 3 OF 7
V-3
Step 1
Step 2
Step 3
Step 4
Step 5
Fig. A
Step 1:
Fasten the front and the rear upright supports
(#2 and #3) at the top by using bolts (#15),
washers (#20), and steel nuts (#25). Repeat the
same procedure for both sides. Keep the bolts
loose. See Fig. A – Step 1.
Do not tighten the bolts
after step 1. Fasten all
of the bolts after step 5.
Step 2:
At both ends, insert the assembled upright
supports (#2 and #3) into the top cross beam
w/adjustable teeth (#1). See Fig. A – Step 2.
Step 4:
Fasten the lateral cross brace (#4) to upright
supports (#2 and #3) by using bolts (#16),
washers (#21), and plastic nuts (#26). Repeat
the same procedure for both sides.
See Fig. A – Step 4.
2
2
2
1
1
15
15
20
20
20
20
25
25
3
3
2
3
2
3
3
ASSEMBLY (Note: For all of the nuts and bolts
fastening, always use a washer (#20, #21, or #22)
between the tube and the bolt or the tube and
the nut.)
STOP DO NOT RETURN TO THE STORE!
26
17
21
21
26 21
21
16
5
2
4
4
3
2
3
3
3
