Count Dyna-Cut, Руководство пользователя

Страница: 16 / 18

DYNA-CUT 16
SETTING PRESSURE ON THE CYLINDER
1. Use 3 pins to line up die on to the magnetic cylinder.
2. Roll the cylinder by had to put the die on.
3. Insure that the vertical marks on the die line up to
verify the die is on straight.
4. Set the pressure on the cylinders by adjusting the
hydro jacks on top of the machine.
5. Set the pressure to 300 psi to start. Run a test sheet
and increase pressure until you get the desired cut.
6. Excessive pressure can cause premature die-wear.