9
EN
GL
IS
H
16
10
23
22
Attaching the circle cutting pin
The router can be used to cut arcs and circles using the hole cutting attachment.
1. Drill a hole in the centre of the circle that is to be removed.
2. Remove the parallel guide, but leave one of the guide rods.
3. Attach the hole cutting attachment (16) to the end of the guide rod.
4. Set the correct radius for the circle.
5. Tighten the guide rod locking knob.
6. Stick the point of the hole cutting
attachment into the centre hole.
7. With the on/off switch set to
OFF
,
move the router around the circle
to check if it is the right size and
make any adjustments.
8. Cut the circle in stages, lowering
the router cutter about 2 mm on
each circuit. Do not try to cut too
deeply in one go.
Attaching the template guide and extractor duct
• Place the extractor duct on the base plate (10).
• Turn the machine upside down and insert the template guide (23).
• Screw both the template guide and extractor duct to the base plate using
the same two machine screws (22).
• If the dust extractor duct is not required use the two nuts to fit onto
the ends of the machine screws.
