PRODUCT ASSEMBLY
PRODUCT ASSEMBLY
other parts of the body.
Wear gloves with colloidal particle. Wear safety goggles.
Do not use damaged or failed cables.
Put the machine near the pipe opening.
Machine safety:
Do not use soft gloves or cloth to hold the rotating flexible shaft, which may cause serious
injury if twined in the flexible shaft.
Do not over-deliver the flexible shaft, excessive deliver due to blockage may cause the
winding or break off of flexible shaft and cause serious injury.
Technical data
Product Features (Figure 1, 2)
1
2
3 4
5
9
8
7
6
1.
flexible shaft
2.
operating handle
3. LED work light
4.
Lock the spring soft shaft 5. drum
6.
lock knob
7. forward & reverse switch
8. variable speed switch
9.
battery pack
Initial operation
-Insertion and Removal of Rechargeable Battery
Ensuring the correct orientation between the battery and the battery compartment, insert the
rechargeable battery into the machine. Do not apply force when inserting the battery. Insertion
can be achieved easily and without resistance. The battery must be inserted completely until the
battery retention clips on the sides of the battery compartment automatically lock it into place.
To remove the battery press the battery retention clips and pull the battery out of its compart-
ment.
-Charging the Battery
The rechargeable battery must be charged before the first use. Only recharge the battery once it
is has been fully discharged, i.e. the performance clearly decreases. Otherwise the battery may
not achieve its full capacity at the subsequent charge.
Important!
Only use the provided battery charger for charging the battery. First place the
rechargeable battery into the charging slot in the charger and then connect the charger to the
mains. Charging starts automatically.
Remove the battery from the charge after about 5 hours. Always disconnect the charger from
the mains before you remove the battery from the charger. The battery capacity indicator is
fully light.
Check before Operation
1. Check if there are damaged machine parts that may pose a threat to your safety.
2. Lubricate the flexible shaft in according to the operation manual.
3. Selection of appropriate accessories for pipe dredge can improve the efficiency and quality of
dredging.
4. Before using, clean up the dirt on handle and the machine body.
5. Check if the flexible shaft is worn or damaged. In the cases of worn flat, corrosion and
bending deformation, please immediately replace the flexible shaft.
6. Check the workplace to ensure sufficient lighting, no flammable liquid, gas or dust. Check
the connection of cable and socket to ensure that the cable will not be damaged.
7. Do not place the side of the flexible shaft towards the operator or other people.
Operating Instructions:
Control
Notice: Before using the machine, you must be familiar with the functions and be proficient in
operating it.
Switch variable speed
Control the speed between 0-560/min, exert pressure on the switch: the greater the pressure,
the higher the speed.
Switch forward and reverse rotation
Type
RC-9101-DC
Voltage
18Vd.c.
Rated speed(n)
n
0
: 0-560/min
Battery cell
Li-ion, 3,7Vd.c., INR18650-15++: 2000mAh
Battery pack
18Vd.c., Li-ion, LQL18V20WH 2.0AH
Charger
Input:100-240VAC, 50-60Hz, 75W; Output: 12V-42VDC, 1.5A
Input:
100-240VAC, 50-60Hz, 65W; Output: 12-42VDC, 1.5A
