Cosmo COS-QB75, Инструкция по установке и эксплуатации

Страница: 7 / 11

12 13
INSTALLATION INSTRUCTIONS RECIRCULATING FILTER INSTALLATION
Step 3 :
Connect installed duct to existing
ductwork. For best performance
a void steep angles in duct work.
Step 4 :
A.
Install the Drip Tray inside the bottom
rear of the range hood.
B. Install the baffle filters by inserting at an
angle towards the rear of the range hood.
Push the filter up and insert front of filter
into front recess. Slightly lower the filter
then slide back until it is in proper position.
Rear Mounted Installation
A. Find the key holes in the back of the range hood.
Mark their locations at the installation location with a
pencil or marker.
B. Drill 5/16
"
(8mm) hole at each of the marked
locations.
C. Insert anchors into each drilled hole. Firmly
screw them into place.
D. Hang your Range Hood into place by aligning the
anchors with the key holes in the back of the range
hood.
Larger images on Pages 6-7
Installing Recirculating Filters (For Ductless Model Only)
Skip this page if you are installing a Ducted Range Hood.
Charcoal Filters are only included with Ductless Models
B
efore installing
m
ake sure the unit is powered off and unplugged.
Additional Aluminum or
B
affle Filters can be purchased from
www.cosmoappliances.com
1. Remove the
B
affle Filters from the Range Hood
2. Locate Fig. 1 , unscrew the 6 screws along the Motor Ring (metal circle).
Set motor ring to the side.
3. Take your
F
ilter
R
ing and align the holes on the motor ring to the holes of the filter ring.
4. Screw the Filter Ring into motor ring.
5. Take the
C
arbon Filter and lock into the Filter Ring by aligning the two tabs and twisting.
6. Repeat Steps 1
-
5 on the other side.
7
. Reattach the
B
affle Filters.
The carbon filter must be replaced every 4-6 months depending on use.
Figure 1
Motor Ring
Filter Ring
Carbon Filter
Motor Housing
Note: This is a top venting unit and a hole must be cut into the cabinet for proper installation.
AFTER CARBON FILTER INSTALLATION